|
A schematic diagram
|
 |
SHELL SPEC
Before a steel shell is brought in for a fit-out, it
is inspected to make sure it is up to our standard. Therefore the thickness
of the steel is specified at the ordering stage. We can use 10mm/8mm base
depending on the size of craft, 6mm hull sides, 5mm cabin and 4mm roof.
When put together by our selected builders this ensures a very stable
craft
which will carry the TRITON name.
There will be an all steel fuel tank of approximately
60 gallons capacity with filler cap and drain off. An intregal water tank
of approximately 150 gallons is standard (but can be changed to polyprop/stainless
steel if required at no extra cost). This is complete with sealed inspector
hatch and filler cap. Bollards are fitted 1 forward, 2 aft, safety rails
(cruiser only), quick release weed hatch, rudder and tiller.
The engine compartment will have engine beares and keel
cooler or mud box. All shells have self draining decks. All shells are
primer painted and have bitumen coatings to hull sides. Shells are fininshed
and painted in a choice of colours selected from our charts.
ENGINES
| LOMBARDINI -engine |
We use a selection of proven canal boat engines
and gearboxes. As a standard we use LOMBARDINI ranging from 2/3/6
cylinders. We can install the engine of your choice providing there
is availabilty and a good source of spares outlets.
|
 |
INTERNAL FITTINGS
Ballast is of concrete pavings on bitumen. Insulation is polystyrene
joblite sheets, 25mm thick. The hull is lined out in a quality treated
ply and covered with carpets.
|
The superstructure and ceiling is fitted out completely
with pine T.G. Gables and internal walls are constructed out of
good quality plywood, all surfaces are sanded and stained where
necessary and finished with two coats of clear lacquer, to leave
a beautiful contrast of colours. Veneered plyboard can be used instead
of T.G, at an extra cost.
|
Example |
 |
| Example |
Most craft are fitted with 2+2+ sleeping accommodation,
with fixed double fitted or loose convertable furniture. Ample storage
space and cupboards and wardrobes. |
 |
| |
Example |
Example |
|
A shower tray and vanity basin set in a cupboard
unit and an Elsan (Porta Potti) toilet. Thretford flush on larger
craft. Pump out toilet can be fitted at an extra cost
|
 |
 |
| Example |
The saloon area is fitted with a T.V. storage unit
and fixed convertable seating or loose convertable furniture (P.O.A
depending type). All floor areas are covered with carpet and matching
vinyl fabrics for curtains and fitted furniture, to be supplied
by customer and made up by TRITON.
|
 |
|
The standard galley is fitted with a four burner
oven with grill cooker, stainless steel sink with drainer, a 12volt
fridge. Cupboard storage units and wall cupboards where you require
them A fixed breakfast bar of dinette table. A (Vanessa 2 burner
cooker on smaller craft). A 12volt electrical system is installed
to feed lighting and power points. An additional 240volt electrical
system can be fitted if required (standard on larger craft)
|
Example |
 |
Standard specifications may change
due to availability.
|
